Presenter Index: B

A B C D E F G H I J K L M N O P Q R S T U V W X Y Z
Babin, S.
Panelist 3
Bae, Y.
Life Cycle Cost Optimization of Residential Buildings (LV-17-C052)
Bahloul, A.
Effects of Air Flow Rates on VOC Removal Performances of Oxidation-Based Air Cleaning Technologies (LV-17-C044)
Bahnfleth, W.
Getting Our House in Order
Baig, M.
Energy and Resources Conservation through O&M
Bailes, A.
Hard Ducts Are Not so Hard
Baltazar, J. C.
Developing EUI Adjustment Factors for Benchmarking Airport Terminal Buildings
Bangerth, S.
Energy Analysis of a LEED Silver Certified Dining Hall on an Academic Campus: A Revisit Three Years after Its Initial Certification (LV-17-012)
Barnaby, C. S.
Standard 205P: Overview and Structure
Bean, R.
What Ducts? Who Needs Ducts?
Beaty, D.
Team A Speaker 1
Behfar, A.
Modeling the Effect of Vapor Compression Cycle Faults Using Gray-Box Models
Bennett, J.
Design Considerations for Industrial Health and Sustainability in Large Aircraft Painting Facilities
Bernstein, R.
Cyber Security
Betz, F.
Air Cooled vs Water Cooled Chillers
Standard 191: Standard for the Efficient Use of Water in Building, Site and Mechanical Systems
Bhandari, M.
Development of Heat Transfer Model for Ceiling Radiant Cooling Panel through Combined Experimental and Simulation Study (LV-17-009)
Bhave, C.
Computational Study of Laminar Flow Heat Transfer Characteristics of Offset Strip Fin Channels (LV-17-C083)
Bianchi, C.
Energy Demands for Commercial Buildings with Climate Variability and Associated Air Quality Impacts (LV-17-C039)
Bidstrup, N.
Future Pump Performance Regulations in EU and USA
Biyikoglu, A.
Comprehensive Design of a Laminar Flow Newborn Incubator (LV-17-C010)
Determination of Heat Transfer Coefficient between Heated Floor and Space Using the Principles of ANSI/ASHRAE Standard 138 Test Chamber (LV-17-007)
Black, W.
Comparison of COSMO Smoke Management Software and Experimental Measurements of Smoke Properties During a Structural Fire (LV-17-C073)
Bludau, C.
Hygrothermal Analyses of Four Different Chilled Water Pipe Insulation Systems in a Hot and Humid Climate
Bobker, M.
Urban-Scale Building Energy Modeling: Why Working at Scale Matters
Boldt, J.
Should Your Water be Used As Delivered? Softened? Blended Back? RO? or What? If Blended Back, How Much?
Boot-Handford, N.
Metropolitan Integrated Cooling and Heating (LV-17-C014)
Bos, J.
Measurement and Exposure of Airline Staff to Tri-Cresyl Phosphates from Engine Oil (LV-17-C045)
Bourdakis, E.
Parametric Analysis of the Control System of Solar Panels for Nocturnal Radiative Cooling Coupled with PCM Ceiling Panels (LV-17-C049)
Brandemuehl, M.
Analysis of Refrigeration and HVAC Impacts on Supermarket Energy Performance (RP-1467) (LV-17-002)
Brannon, A.
Integrating Energy Analysis into Design: How to Ensure Predicted Energy Utilization Index Values Are Achieved
Branson, D. J.
Team B Speaker 2
Brass, B.
Effect of Economizer Faults on Expected Whole-Building Energy Savings
Brayman, W. J.
Air Conditioned Football Stadium and Convention Center Chilled Water Pipe Insulation Assemblies Failure and Remediation with New Developed Insulation Systems
Brendel, M.
Standardizing Fan System Energy Calculation
Brown, S.
Measurement and Verification of Efficiency Upgrades in Chilled Water Systems (LV-17-020)
Bruenn, T.
Basics of Hydronic Control Valve Sizing
Bruning, S.
Defining the Baseline for BIM Loads Comparison
Field Application of LED Lighting Heat Gain Distribution Data
Bucking, S.
Optimization Under Economic Uncertainty: Effect of Solar Variability on Energy and Economic Indicators (LV-17-021)
Burkhead, B.
Dusting Off Some Research: From RP-1284 to Standard 199 Test Results
Bush, J.
The Application of Icephobic Coatings to Air-Source Heat Pumps (LV-17-C075)
Butterfield, J.
BIM-Enabled Operations and Maintenance Work Processes (RP-1609) (LV-17-003)
A B C D E F G H I J K L M N O P Q R S T U V W X Y Z

Register now!